In my last post I suggested using Toothpaste to Restore Cloudy Headlights. It will work…. if you spend the whole day doing it!
To save yourself time and sanity I'd suggest buying a 3M Headlight Restoration Kit. These kits range in price from $15-20, and generally work well. For restoring the headlights on my Mom's '97 Chrysler Town & Country I bought the 3M Headlight Restoration Kit. It took me about 4 hours to do it properly. The process is basically what a body shop would do to restore and refinish headlights. Except you use a drill and save a ton of money since you DIY!
Here are Pictures of the Before and After on my Mom's '97 Chrysler Van.
I did this on March 6th, 2010. That was about 2 months ago, and the headlights still look pretty good. The headlights were so dim nobody wanted to drive the Town & Country at night, but now that's not a problem. (Well I don't want to drive it because it's van but that is obviously a separate issue.)
Restoring your headlights is extremely beneficial for your safety and other drivers out on the road. Not only did this improve the appearance of the van, but the ability to see the road at night and in bad weather greatly improved and other people will be able to see the van better.
It's possible the headlights will get cloudy again, meaning I might have to buy another headlight restoration kit and redo this. If you want to avoid this in the future I would recommend going down to your local auto parts store and buying a UV clearcoat spray in a can. Headlights that come from the factory have a UV clearcoat protection on them, which helps protect from UV damage and debris. Generally when the UV clearcoat wears off is when you start to get cloudy, hazy, and yellowed headlights.
The 3M Headlight Restoration Kit doesn't have any sort of clearcoat spray that comes with the kit. Some kits, like the Slyvania Headlight Restoration Kit, come with a UV clearcoat application. I should put a protective UV coating on the van's headlights, to ensure I don't need to refinish the headlights again. I would recommend you do the same if buy the 3M kit.
Here are some tips for the 3M kit:
- I was oversanding with the 600 grit sandpaper. The paper would gum up, before I realized it. It probably would have been helpful to wet the 600 grit paper a little bit every so often.
- You get only 1 piece of 3000 grit sandpaper. It would have been helpful to have 2 pieces in my opinion. I did one headlight then I moved onto the other one, but by then the paper was used up. It took me forever to do the other headlight. I would suggest switching back and forth on each side if you are headlights are really cloudy, hazy, or yellowed.
- You must Tape-up around your Headlights! I probably would have done a lot of damage to the paint if I didn't! I just used blue Painters Tape you can buy at any local hardware store, which worked fine.
- I would suggest using a Corded Drill, which is what I used. If you try to use a Battery Powered Drill, I'm sure the battery will run out before you finish and you will be waiting for the batteries to charge.
- As the video says in the beginning you definitely should have a Spray Bottle and some microfiber towels.